200-150 Real Exam Dumps Questions and answers 91-100
Get Full Version of the Exam
http://www.EnsurePass.com/200-150.html
Question No.91
In an IEEE 802.3 Ethernet frame, what is the significance of the DSAP field?
-
The DSAP field specifies the TCP or UDP port that is associated with the transport protocol.
-
The DSAP field is only used on United States Department of Defense networks to indicate the information classification level.
-
The DSAP field is only used in Ethernet II frames.
-
The DSAP field indicates the network layer protocol.
Correct Answer: D
Question No.92
What is the maximum of fabric modules that can be installed in a Cisco Nexus 7000 chassis?
A. |
5 |
B. |
6 |
C. |
4 |
D. |
7 |
Correct Answer: A
Question No.93
Which command can change the sequence of a router boot process?
-
config-register
-
configuration-register
-
conf-register
-
config-registration
Correct Answer: A
Question No.94
When comparing TCP and UDP segments, which two fields are found only in TCP segment? (Choose two.)
-
Checksum
-
acknowledgement
-
length
-
source
-
Sequence number
Correct Answer: DE
Question No.95
Which two layers of the OSI model are combined in the Internet protocol suite network access layer? (Choose two.)
-
1
-
2
-
3
-
4
-
5
-
6
-
7
Correct Answer: AB
Explanation:
http://en.wikipedia.org/wiki/Internet_protocol_suite
Question No.96
A switch is configured to be part of a VTP domain so that its VLAN database is not affected by any changes in the domain. Which mode should be configured on this switch?
-
client
-
transparent
-
server
-
neutral
Correct Answer: B
Question No.97
Which command displays the Trunking Native Mode VLAN on port Ethernet 1/18?
-
show running-config switchport e1/18
-
show running-config e1/18 switchport
-
show interface e1/18
-
show interface e1/18 switchport
-
show interface e1/18 native
Correct Answer: D
Explanation:
NX# show interface e1/18 switchport Access Mode VLAN: 1 (default) Trunking Native Mode VLAN: 1 (default) Trunking VLANs Allowed: 1-4094
Voice VLAN: none
Question No.98
Refer to the exhibit. Which result command is true?
N7k(config)# interface Ethernet 1/1 N7k(config-if)# storm-control broadcast level 0
-
All broadcast traffic is suppressed on Ethernet 1/1.
-
All broadcast and multicast traffic is allowed on Ethernet 1/1.
-
All broadcast traffic is allowed on Ethernet 1/1.
-
All broadcast and multicast traffic is suppressed on Ethernet E1/1.
Correct Answer: A
Question No.99
Which statement describes the use of zones in a VSAN?
-
zones are configured at the fabric core.
-
An HBA or storage device can belong to one zone.
-
zones limit unicast, multicast, and broadcast traffic.
-
zones are a group ports within a single VSAN.
Correct Answer: D
Question No.100
To witch component do you connect the Layer 1 port of a fabric interconnect?
-
Layer 2 port of the opposite fabric interconnect
-
out-of band management network
-
Layer 2 port of the same fabric interconnect
-
Layer 1 port of the opposite fabric interconnect
Correct Answer: D
Get Full Version of 200-150 Dumps