200-301 Real Exam Dumps Questions and answers 21-30

Get Full Version of the Exam
http://www.EnsurePass.com/200-301.html

Question No.21

What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?

A.

The Layer 2 switch drops the received frame

B.

The Layer 2 switch floods packets to all ports except the receiving port in the given VLAN.

C.

The Layer 2 switch sends a copy of a packet to CPU for destination MAC address learning.

D.

The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table

Correct Answer: B

Question No.22

DRAG DROP

Refer to the exhibit. Drag and drop the networking parameters from the left onto the correct values on the right.

image

Check the answer below.

image

Question No.23

Which two encoding methods are supported by REST APIs? (Choose two)

A.

YAML

B.

JSON

C.

EBCDIC

D.

SGML

E.

XML

Correct Answer: AE

Question No.24

Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol?

A.

on

B.

auto

C.

active

D.

desirable

Correct Answer: D

Question No.25

A frame that enters a switch fails the Frame Check Sequence. Which two interface counters are incremented? (Choose two)

A.

runts

B.

giants

C.

frame

D.

CRC

E.

input errors

Correct Answer: DE

Question No.26

Which output displays a JSON data representation?

image

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Correct Answer: C

Question No.27

Which design element is a best practice when deploying an 802.11b wireless infrastructure?

A.

disabling TPC so that access points can negotiate signal levels with their attached wireless devices.

B.

setting the maximum data rate to 54 Mbps on the Cisco Wireless LAN Controller

C.

allocating nonoverlapping channels to access points that are in close physical proximity to one another

D.

configuring access points to provide clients with a maximum of 5 Mbps

Correct Answer: C

Question No.28

DRAG DROP

Drag and drop the functions from the left onto the correct network components on the right.

image

Correct Answer:

image

Question No.29

Which API is used in controller-based architectures to interact with edge devices?

A.

overlay

B.

northbound

C.

underlay

D.

southbound

Correct Answer: D

Question No.30

Refer to the exhibit. The show ip ospf interface command has been executed on R1 How is OSPF configured?

image

A.

The interface is not participating in OSPF

B.

A point-to-point network type is configured

C.

The default Hello and Dead timers are in use

D.

There are six OSPF neighbors on this interface

Correct Answer: A

Get Full Version of 200-301 Dumps

Tagged

Leave a Reply

Your email address will not be published. Required fields are marked *