350-801 Real Exam Dumps Questions and answers 91-100

Get Full Version of the Exam
http://www.EnsurePass.com/350-801.html

Question No.91

An engineer with troubleshoots poor voice quality on multiple calls. After looking at packet captures, the engineer notices high levels of jitter. Which two areas does the engineer check to prevent jitter? (Choose two.)

A.

Voice packets are classified and marked.

B.

All devices use wired connections instead of wireless connections.

C.

The network meets bandwidth requirements.

D.

Cisco UBE manages voice traffic, not data traffic.

E.

MTP is enable on the sip trunk to cisco Unified Border Element.

Correct Answer: AC

Question No.92

Which command is used in a Cisco IOS XE TDM gateway to configure the voice T1/E1 controller to provide clocking?

A.

Clock source network

B.

Clock source line

C.

Clock source internal

D.

Cisco IOS XE TDM gateway T1/E1 controller cannot provide clocking.

Correct Answer: A

Question No.93

image

A user dials 9011841234567 to reach Vietnam. Which steps send the call to the PSTN provider as 011841234567?

A.

B.

C.

D.

Correct Answer: A

Question No.94

How can an administrator stop Cisco Unified Communications Manager from advertising the OPUS codec for recording enabled devices?

A.

In CUCM Service Parameters set quot;Opus codec Enablesquot; to quot;Enabled for all devices Except Recording-Enabled devices.

B.

Go to the phone#39;s configuration page and set quot;Advertise OPUS Codecquot; to be quot;falsequot;.

C.

Router recorded calls through Cisco Unified Border Element because it does not support OPUS.

D.

Integrate the Cisco Unified CM with a recording solution that does not support OPUS.

Correct Answer: A

Question No.95

When deploying Mobile and Remote Access (MRA), which two SAN entries are mandatory in the Expressway Series certificates for secure phone registration? (Choose two.)

A.

Unified CM Phone security profile name in Expressway-C certificate

B.

Unified CM registration domain in Expressway-C certificate

C.

Unified CM Phone security profile name in Expressway-E certificate

D.

IM and Presence Chat node alias in Expressway-C certificate

E.

IM and Presence Chat node alias in Expressway-E certificate

F.

Unified CM registration domain in Expressway-E certificate

Correct Answer: AF

Question No.96

How is Video Call Traffic Class defined on Cisco Unified CM for Enhanced Location CAC bandwidth deductions?

A.

On each device#39;s configuration page

B.

On Device Profile page

C.

On SIP Profile configuration page

D.

On Location configuration page

E.

On each device or Device Pool#39;s configuration page

Correct Answer: D

Question No.97

Refer to the exhibit. Assume that the bottom logical partition policy entry in Cisco Unified Communications Manager was provisioned last. How is the call treated when an IP phone in the Bangalore GeoLocation places a call to a MGCP gateway with FXS ports in the San Jose GeoLocation?

image

A.

The call is denied because the last added logical partition policy takes precedence when multiple matches exist.

B.

The call is allowed because the first listed logical partition policy takes precedence when multiple matches exist.

C.

The call is denied because the call flow matches neither policy entries.

D.

The call is allowed because the call flow matches neither policy entries.

E.

The call is allowed because only the top policy entry matches the call flow.

Correct Answer: A

Question No.98

Due to provider requirements, outgoing calls from the Enterprise to the PSTN must start with channel 1. Which ISDN command changes the channel selection on IOS to meet this requirement?

A.

isdn bchan-number-order ascending

B.

isdn protocol-emulate network

C.

isdn incoming-voice

D.

isdn bchan-number-order decending

image

Correct Answer: A

Question No.99

Refer to the exhibit. An engineer configures a VoIP dial peer on a Cisco gateway. Which codec is used?

image

A.

G.711ulaw

B.

No codec is used (missing codec command).

C.

G.711alaw

D.

G.729r8

Correct Answer: D

Question No.100

How can an engineer determine location-based CAC bandwidth requirements for Cisco Unified communication Manager?

A.

Execute the Resource Reservation protocol to return location-based requirements.

B.

Calculate the number of calls against the license for Cisco Unified Border Element to determine calls per location.

C.

Set the requirements in the service parameters.

D.

Add the requirements for each audio and video codec and how many calls must be supported.

Correct Answer: D

Get Full Version of the Exam
350-801 Dumps

Tagged

Leave a Reply

Your email address will not be published. Required fields are marked *