Cisco console rollover cable

A rollover cable is usually shipped with each Cisco device. This cable connects a serial port on your computer to the console port of the device and it is used for the device’s initial configuration. It is called rollover because the wires on one end are rolled at the other end – the wire at pin 1 connects to the pin 8 on the other side, the wire at pin 2 to the pin 7, etc.

The cable is of light blue color with a DB-9 connector at one end and a RJ-45 connector at the other:

Cisco rollover cable

You connect the rollover cable to the serial port on your computer. On the Cisco device, there is a blue console port (usually marked in blue) to which you connect the other end of the cable:After the cable is connected, you can access the device using the terminal emulation software (e.g. Putty or HyperTerminal). You need to configure the PC’s serial port to match the console port settings. Here are the defaults:

  • 9600 baud
  • no hardware flow control
  • 8 data bits
  • no parity bits
  • 1 stop bit

 

Cisco serial port configuration

NOTE
Newer Cisco devices usually include a USB console port, since serial ports are rare on modern PCs.

Prerequisites for 200-301

200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.

The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.

Full Version 200-301 Dumps

Try 200-301 Dumps Demo