By default, Cisco switches forward Ethernet frames without any configuration. This means that you can buy a Cisco switch, plug in the right cables to connect various devices to the switch, power it on, and the switch will work properly.
However, to perform switch management over the network or use protocols such as SNMP, the switch will need to have an IP address. The IP address is configured under a logical interface, known as the management domain or VLAN. Usually, the default VLAN 1 acts like the switch’s own NIC for connecting into a LAN to send IP packets. Here are the steps to configure an IP address under VLAN 1:
- enter the VLAN 1 configuration mode with the interface vlan 1 global configuration command.
- assign an IP address with the ip address IP_ADDRESS SUBNET_MASK interface subcommand.
- enable the VLAN 1 interface with the no shutdown interface subcommand.
- (Optional) use the ip default-gateway IP_ADDRESS global configuration command to configure the default gateway.
- (Optional) Add the ip name-server IP_ADDRESS global configuration command to configure the DNS server.
Here is a simple example network:
We have a simple network of a host and a switch. We can assign the switch with an IP address to enable IP communication between the two devices:
SW1(config)#int vlan 1 SW1(config-if)# SW1(config-if)# SW1(config-if)#ip address 10.0.0.2 255.0.0.0 SW1(config-if)#no shutdown SW1(config-if)# %LINK-5-CHANGED: Interface Vlan1, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to up
To verify the IP address set on a switch, we can use the show int vlan 1 command:
SW1#show int vlan 1 Vlan1 is up, line protocol is up Hardware is CPU Interface, address is 0030.a3e8.6b3c (bia 0030.a3e8.6b3c) Internet address is 10.0.0.2/8 ....
We can verify that the host can reach the switch using its IP address by pinging it from Host A:
C:\\>ping 10.0.0.2 Pinging 10.0.0.2 with 32 bytes of data: Reply from 10.0.0.2: bytes=32 time<1ms TTL=255 Reply from 10.0.0.2: bytes=32 time<1ms TTL=255 ...
Prerequisites for 200-301
200-301 is a single exam, consisting of about 120 questions. It covers a wide range of topics, such as routing and switching, security, wireless networking, and even some programming concepts. As with other Cisco certifications, you can take it at any of the Pearson VUE certification centers.
The recommended training program that can be taken at a Cisco academy is called Implementing and Administering Cisco Solutions (CCNA). The successful completion of a training course will get you a training badge.
Full Version 200-301 Dumps